Solid carbide tooling · Custom geometries · Worldwide shipping

Exactalloy0

Recoat After Regrind? A Decision Table by Workpiece Material

November 21, 2026 · 铸屹精密

Whether a reground tool needs recoating depends far more on the workpiece material and cutting regime than on habit. This article gives a material-banded decision table: aluminum and non-ferrous alloys often run better with a bright sharp edge and no coating, steels and stainless almost always pay back an AlTiN or AlCrN recoat in life and chip control, and hardened steel above HRC50 makes recoating near-mandatory. It lists the five hard conditions a tool must meet before recoating is worth the money - enough remaining flute length, intact geometry, a clean edge, no micro-cracking, and a stable regrind - plus the cost math that separates worthwhile recoats from wasted ones.

Further reading

Volume pricingLower unit prices as you buy more
154 currenciesConverted at daily exchange rates
Shipping methodAvailability and cost depend on destination
Secure paymentCard payments processed by Stripe
Recoat After Regrind? A Decision Table by Workpiece Material — Exactalloy