Solid carbide tooling · Custom geometries · Worldwide shipping

Exactalloy0

Aluminum Built-Up Edge and Chatter Marks: Recoat After Regrind, or the Money Is Wasted

November 19, 2026 · 铸屹精密

In aluminum machining, built-up edge and visible chatter marks usually mean the tool edge condition and coating are wrong, not the parameters alone. This article explains the correct order: regrind first to restore a sharp, polished edge geometry - a dull edge smears aluminum and grows BUE regardless of coating - then apply an appropriate coating; uncoated polished edges work for pure aluminum, while DLC or similar low-friction coatings help silicon-containing alloys. It warns that recoating a worn edge seals defects under the coating and shortens life, gives parameter checks (feed per tooth floor to avoid rubbing, chip evacuation in deep pockets), and a sequence to diagnose whether the marks come from edge, coating, or vibration.

Further reading

Volume pricingLower unit prices as you buy more
154 currenciesConverted at daily exchange rates
Shipping methodAvailability and cost depend on destination
Secure paymentCard payments processed by Stripe
Aluminum Built-Up Edge and Chatter Marks: Recoat After Regrind, or the Money Is Wasted — Exactalloy