Sharpening Engraving and Carving Tools: Repair In-House or Send Out, by Tool Diameter
November 19, 2026 · 铸屹精密
Engraving cutters and other micro tools change character with diameter: above roughly 3-4 mm you can touch them up in-house with fixture guidance; below that, hand sharpening usually destroys concentricity and the tip geometry that does the actual cutting. This article grades the decision by diameter and tool type (V-bits, flat engraving tips, small ball noses), gives the in-house method that works - guided fixtures, light passes, strop finishing - and the send-out criteria, including how much a regrind should cost relative to a new micro tool. It closes with handling and storage practices that cut the sharpening frequency in half for mold-detail work.