How to Choose Parting & Grooving Tools: A Complete 2026 Selection Guide

August 16, 2026 · Exactalloy Technical Team

Choosing the wrong parting and grooving tools costs more in scrap, tool changes and cycle time than the tool itself. This guide walks through the six decisions that determine performance.

Quick answer: Match the tool to (1) workpiece material and hardness, (2) operation type, (3) machine capability and coolant, then (4) pick substrate, (5) coating and (6) geometry. Exactalloy stocks parting and grooving tools from up to HRC 45 across 1 standard lines.

Step 1 — Identify the workpiece material and hardness

Steel, stainless steel, cast iron, aluminium, brass. Hardness above HRC 45 usually rules out standard grades and pushes you to PVD TiAlN, uncoated polished.

Step 2 — Match tool geometry to the operation

Available geometries: parting, external grooving, internal grooving, thread grooving. Choose the shortest flute length and largest core diameter that reaches the feature.

Step 3 — Select substrate and coating

Typical coatings for this family are PVD TiAlN, uncoated polished. Coating choice trades wear resistance against edge sharpness and cost.

Step 4 — Set cutting parameters

Start from the manufacturer surface speed, then adjust feed per tooth until chip formation is correct. Rigid set-ups tolerate higher feeds.

Step 5 — Verify run-out and coolant

Run-out above 0.01 mm shortens tool life sharply; measure at the cutting edge, not the shank. Through-coolant extends life in deep pockets.

Specifications at a glance

Decision	What to check	Typical answer
Material	Hardness, ISO group	steel
Geometry	Operation, reach	parting
Coating	Abrasion vs adhesion	PVD TiAlN
Coolant	Depth, chip evacuation	Through-coolant for depth > 2×D

Frequently asked questions

What hardness can these tools handle?

This family typically covers up to HRC 45, verified by the substrate grade and coating.

Can I use one tool for roughing and finishing?

Not optimally — roughing geometries trade edge sharpness for strength, so finishing needs a separate tool.

Do I need through-coolant?

Required for holes or pockets deeper than twice the diameter, or where chips cannot escape.

Get a quote and technical support

Exactalloy supplies parting and grooving tools from stock, made-to-order and reground. Send your drawing or specification for a quotation and lead time within 24 hours. Contact us or browse all products.