Solid carbide tooling · Custom geometries · Worldwide shipping

Exactalloy0

End Mill Cutting Parameters: RPM, Feed Per Tooth and Depth of Cut

November 19, 2026 · Exactalloy

What spindle speed should I use for a 6 mm carbide end mill in aluminium?

Work from surface speed, not from a fixed rpm. For aluminium, a starting range of 300 to 500 m/min surface speed puts a 6 mm tool at roughly 16,000 to 26,000 rpm. Most machines cannot reach that, which is fine: run at the machine maximum with adequate chip load and let the feed per tooth do the work. Verify on a test cut and watch for built-up edge and chip welding, which tell you the speed is too low or the coolant is inadequate.

How many flutes should an aluminium cutter have?

One flute for deep pockets and roughing where chip evacuation limits you, three flutes for a balance of finish and productivity, and two flutes for general work. More flutes means less chip room, and aluminium chips are bulky, so a 4-flute tool in a deep slot will clog even with good coolant. For finishing walls and floors where the chip load is small, three flutes is usually the sweet spot.

How many flutes for steel?

Four flutes is the default for general steel milling, five or six for finishing passes where chip room is not the constraint. Fewer flutes give more chip room and better performance in soft, gummy steels; more flutes give a stronger core and better finish at lower feed per tooth. In stainless, avoid very high flute counts unless your chip evacuation is genuinely good.

What feed per tooth should I start with?

For a 6 mm carbide tool in aluminium, 0.02 to 0.05 mm per tooth is a reasonable starting window. In steel, start around 0.02 to 0.04 mm per tooth and adjust from the chip: thin, powdery chips mean you are rubbing, thick blue chips mean you are overloading. Feed per tooth matters more than table feed, because it controls whether the edge cuts or rubs. Always verify on scrap before running a production batch.

What depth of cut should I take?

Two stable strategies exist: light radial engagement with a large axial depth (high-efficiency milling), or the reverse. For aluminium, a radial depth of 5 to 10 percent of diameter with an axial depth of one to two diameters is efficient on a rigid machine. On a lighter machine, reduce axial depth first and keep the feed per tooth up, because starving the feed is what destroys edges.

Do I need coolant when milling aluminium?

You need chip evacuation more than you need cooling. Flood coolant, MQL, or high-pressure air can all work, but a weak dribble of coolant is the worst option: it creates thermal cycling without clearing chips. For deep pockets, air blast plus a polished flute often outperforms flood. For finishing cuts where surface finish matters, flood is easier to control.

Can I machine graphite dry?

Yes, and you generally should. Graphite is machined dry with dust extraction; coolant turns the dust into a conductive slurry that migrates into ways, bearings, and electronics, and it is far harder to remove than dry dust. Use a sealed machine or a dedicated graphite cell, extract at the cut line, and treat the dust as a health hazard requiring proper filtration.

Want this checked against your own part?
Send your material, operation and existing parameters — an application engineer replies with a tool suggestion and, if useful, a trial-cut sample.
Chat on WhatsApp
Volume pricingLower unit prices as you buy more
154 currenciesConverted at daily exchange rates
Shipping methodAvailability and cost depend on destination
Secure paymentCard payments processed by Stripe
End Mill Cutting Parameters: RPM, Feed Per Tooth and Depth of Cut — Exactalloy